Quick Start Guide

Step 2. Activate the egg:
1) Open the dust cover (B) to find the charging port (C), connect the device to a safe
power source (5V ⎓ 1A) using the provided power cable (D).
2) Shake it or gently knock it against hard surface for 5 seconds, when the LED indicator
blinks in blue, your Smart Egg is activated. See Fig. 2
Step 3. Unplug the cable, put the dust cover back in place. Strap the device to your Mini or
Maxi scooter using the silicon belt provided. See Fig 3
Step 4. Open the Smart Micro Egg APP, follow the instruction to start your ride! (more info
see below instructions) Reminder: please keep the scooter straight for calibration before
starting any ride.
For installation instruction video, please visit out YouTube channel
www. Youtube.com/xxxxxxx
Smart Micro Egg – Hardware
LED indicator:
No Light – The device is not activated, please go back to “Getting started”
Red Light – Battery is low, please charge.
Slow blinking blue light – Smart Micro Egg is activated and in idle mode.
Frequent blinking blue light – Smart Micro Egg is disconnected but is actively looking for
connection.
Constant blue light – Smart Micro Egg is connected to your smart device.
Battery Charging.
Connect the device to a 5V ⎓ 1A USB power adaptor, using the provided charging cable.
DC 3.5 mm
The LED indicator turns red while charging, and turns off when fully charged.
Recharge time: 2 hours
Bluetooth Set up info (only by factory):
• The operating frequency bands of this device are: 2.400 - 2.4835 GHz ISM band.
• The maximum output power of this device is: +4dBm.
• Recommended range: 5 meters.