SPECIAL NOTE: Read instructions for proper care in handling and operation, Use in well ventilated area. Always read and follow instructions, cautions, and warnings o materials being sprays. See back page for further information. At BADGER AIR-BRUSH CC. we are extremely proud of our people and our products.
Reservoir, Hold the front shell of tha air brush firmly to attach or remove the pains jar ta avoid necessary wear and tear on the rotary seal, Give the stem of the Jar adapter 4 slight counter clockwise tum to snug the jar securely Ina place. To remove the jar when finished pull down and estate in a clockwise irradiation. Once your air source is an, and your sir brush i properly connected and set up, you are realty to begin air brushing. To begin operation of the air brush depress the ringer.
ROTARY SEAL The rotary deaf (see photograph 1? tht allows the head of the Mode! 360 to turn needs no maintenance. if replacement is ever needed, the air brush can e sent to Badger for installation, or a replacement seal {with instructions can be sent to fhe customer, Av old subjecting the rotary seal area fo bending farces; this may shorten seal life.
(51-043% This will allow the needier tube to slide out of the front of the tube shank. The needle tuba spring (50-044) can be removed from the tube shank by unscrewing the spring screw from the end of the tube shank. Reassembly Is essentially the reverse.
EXERCISE TWO G a board or paper, lightly pencil in a number of inch squares. Hold the air brash about 1, inch from the surface and spray snail dots an the intersecting lines, as shown In fig. 4. When you are able to place the dots accurately, begin enlarging the size of the dots {fig. 5) by allowing more color to flow through the alr . o airbrush, At the samey time increase the distance s e s between the air brush and the paper o board.
TECHNIQUES TO USE Masking or frisked is used mostly to create a sharp edge or when more than one color is applied, A new y (risked is cut for each color and covers any area that should not B be sprayed. Badger's FRISKINESS FILM™ is specially formula .} g for use on all surfaces commonly used for air Rushing.
H) Carved stroke. Caused by arcing anm lou close to the papa. Arm should always be parallel to the work, unless this affect is desired. 8) Bubbles through the dolor cup. The spray regulator might be turned out too far, or the head may be loose. Heck bot it and tighten i necessary. 9) Color spray cannot be shut oft, Tip may be clogged. This & recognized by & “spongy” feel wham beadle is set into tip. Remove the head from the air brush and clean the tip ses Maintenance and Cleaning, page 3. 16} Pulsating.
