User Manual

HOW TO USE
HOW TO USE
14 15
Use the 1/4” Leg (5) against the fence for
cutting width (Inside Cut) of 1/4” to 5/8”.
Note the location of the Handle (1) above
the cut line in order to apply balanced
pressure to both sides of the stock.
INFO: This is a translucent bottom
view with the table saw top removed
for clarity. The GRR-RIPPER GR-200 is
feeding irregularly shaped stock to obtain
a straight edge. Notice the 1/2” Leg (5)
does not cover the stock edge completely.
The Adjustable Spacer (8) is used with
the smooth side down and leveled with
table top to prevent the tool from tipping
over and to glide against the rip fence for
a parallel feed. INFO: Watch the online
video: http://bit.ly/straight-line-ripping
WARNING! Always visually check the Saw Blade Tunnel has enough clearance
for the saw blade to pass through safely before turning on the saw.
INFO: All table saw illustrations in this instruction manual show a 1/8” kerf saw
blade and a rip fence that is secured parallel and to the right of the saw blade.
Inside Cut = Cut between rip fence and the saw blade, is usually the keeper piece.
Outside Cut = Cut on the left side of saw blade, is usually the off-cut piece.
Use the 1/2” Leg (4) against the
fence for cutting width (Inside Cut)
of 5/8” to 3 3/16”. Use the Balance
Support (6) when stock is not wide
enough to be under the Side Leg on
the left. The Handle (1) is secured
more towards the right side of saw
blade since no pressure is required
on the left side of the cut.
Rip Fence
5
8
Irregularly Shaped Stock
Figure 16
Figure 17
Outside Cut Inside Cut
Balance
Support
1/2” Leg
4
6
1
Figure 15
Outside Cut Inside Cut
Rip fence parallel
to the saw blade
Always keep the
GRR-RIPPER in full
contact against
the rip fence
1/4” Leg
Saw Blade
5
Figure 14
1
Using the Balance Support (6) against
the fence will provide an additional
2” of cutting width. The Adjustable
Spacer (8) can be used on the left as a
balancing device.
Skew Handle (1) to exert “auto” pressure against
the fence when pushed.
Balance
Support
6
8
Adjustable
Spacer
1
USING THE 1/4” LEG USING THE 1/2” LEG
BALANCE SUPPORT SPACERIRREGULARLY SHAPED STOCK
Add a wooden spacer
for thicker stock - use #8 pan head
wood screws & washers (not included).