User Manual

ASSEMBLY
ASSEMBLY
10 11
STEP 5
Brass Inserts
Balance Support
6
1. Attach Thumb Screws (E) to Balance
Support (6). 2. Assemble Balance
Support (6) to either Basic Model GR-100
completed Side Leg (4) or (5).
INFO: If you purchased the GRR-RIPPER
Advanced Model GR-200 or the Upgrade
Kit GRAK-404, please proceed to Step 6
on Page 11.
TIP: To keep the non-slip pads
working most effectively, clean the
contact surfaces with denatured
alcohol or household rubbing alcohol
and a shop rag, prior to use. Repeat
cleaning during use as necessary
when saw dust accumulates. Do not
use if Green GRR-RIP is not effectively
gripping the workpiece. Please
contact MICROJIG in regards to
product issues.
E
x2
A
x2
C
x2
STEP 6
ASSEMBLY – GRR-RIPPER ADVANCED
MODEL GR-200 (GR-100+GRAK-404)
INFO: Assembly video available online at
http://bit.ly/grr-ripper-assembly
With hardware installed, snap the Stabilizing
Plate (7) into the open slots of the Balance
Support (6). Do not tighten completely.
Attach to Balance Support (6) and tighten
when desired position is achieved. It is by
design that the open slots are narrower
than the Shoulder Washer (P), so that the
Stabilizing Plate (7) will remain in place during
adjustments. The Stabilizing Plate (7) can also
be used with its straight edge facing
the GRR-RIPPER. TIP: Push the Orange
O-Ring (D) through the T-Bolt (M) all the
way down, making contact with the
Stabilizing Plate (7) before inserting the
Shoulder Washer (P) and the Thumb Knob (N).
7
6
On top of slot
N
x2
P
x2
Orange
D
x2
M
x2
D
P
Reversible
The Adjustable Spacer (8) can be attached
to either Side Leg on the right or the
left. It can be used with the non-slip pad
downward to provide an additional
gripping surface pressure. Lower it to
achieve two levels of pushing surfaces.
It can also perform as a “balancing device”
with the non-slip pad facing upward.
STEP 7
COMPLETED GR-200
8
Brass Insert
Adjustable
Spacer
Black
E
x2
COMPLETED GR-100
Figure 9
Figure 10
Figure 11
Figure 13
Figure 12
C
x2
A
x2
Reversible