User Manual

OPERATION PRECAUTIONS & SAFETY
8
Do not use this product while under
the influence of drugs, alcohol or any
medication.
To clean this product, use denatured
(available at the paint department of
home improvement centers) or rubbing
alcohol (available at drug stores).
Do not use this tool if any of the
components are damaged. Contact
your dealer or the manufacturer for
replacement parts.
When not in use, store this product on a
flat and clean surface.
The machine tabletop used in
conjunction with this tool must be
flat and free from obstructions other
than the required fence and one
cutting element. The tabletop must
be reasonably level and below the
waistline.
You must have a sturdy and straight rip
fence with a flat front surface preferably
at least 3” in height and square to the
table saw top. The rip fence must be
long enough to cover the entire depth
from the front to the rear of your table
saw top. The rip fence must also be
equipped with a locking mechanism to
secure it on the table saw top so that it
is parallel to the saw blade at all scale
settings. WARNING! DO NOT SKEW
THE RIP FENCE! The GRR-RIPPER is
designed to feed wood parallel to the
saw blade.
The rip fence should also be accurately
calibrated to a fixed scale to secure a
precise cutting width setting.
A sharp and clean carbide-tipped saw
blade should be used with this tool for
ripping, unless otherwise specified.
A Zero-Clearance Throat Plate or insert
(ZCI) should always be used when
cutting narrow strips. INFO: Watch our
online video on how to install a Zero-
Clearance Throat Plate: http://bit.ly/
install-zci
Brass Inserts
Side Legs
54
&
ASSEMBLY
9
ASSEMBLY – GRR-RIPPER MODEL GR-100
INFO: Assembly video available online at http://bit.ly/grr-ripper-assembly
INFO: If you purchased a GRR-RIPPER Handle Bridge Kit (GRHB-010), please refer to its
instruction manual for installation first and resume GRR-RIPPER assembly at Step 2.
1. Install both Side Legs (4) and (5) in
the same manner to opposite sides of
the Main Body (2). 2. Insert the screws
and washers through the front screw
holes, insert the O-Rings from the back
side. See Figure 8 for detail. INFO:
If you purchased the GR-200, do not
confuse the Black smaller O-Ring (C)
and the Orange larger O-Ring (D).
STEP 3 & 4
Handle
1
Main Body
2
3
2
1
G
x2
x2
x2
Assemble Handle (1) to the top slots of
Main Body (2).
STEP 1
Close-up view with
Handle and Center Leg
installed on Main Body
Close-up of O-Ring
embedded in
counter-bore
Figure 5 Figure 7
Figure 8
Figure 6A
1. Attach mounting hardware to Center
Leg (3). 2. Assemble Center Leg (3) to the
end slots of Main Body (2) (see Figure 6A).
STEP 2
Main Body
2
3
Center Leg
x2
F
x2
H
Figure 6
WARNING! Never wear loose
clothing, gloves, bracelets or other
jewelry that may get caught in the
moving parts or cutting elements.
MAINTENANCE
TABLE SAW PREPARATION
B
K
L
x4
G
H
x4
C
x2
A
x4
A