User Manual

WARNING! The GRR-RIPPER 3D Pushblock system is able to control stock
narrower or shorter than the GRR-RIPPER on woodworking machines. You must
make sure that the Balance Support and the Adjustable Spacer are properly
adjusted to keep the GRR-RIPPER balanced on the stock so it will not tip in any
direction, example shown in Figure 16 on Page 15.
WARNING! You must pay attention to the gripping effectiveness of the Green
Non-Slip pads before every use, do not use the GRR-RIPPER if you feel it is not
gripping the stock, clean with denatured/rubbing alcohol or replace the leg(s) with
new Green GRR-RIP
®
non-slip pads, if necessary.
TIP: Parts listing page folds out for
your convenience. Reference this page
during assembly.
Have questions? Need support? Contact MICROJIG directly.
Phone: 1-855-RIP-SAFE
|
International: 1-407-696-6695
|
Email: [e-mail]
Online: MICROJIG.com/support
Work safer. Work smarter.
GRR-RIPPER PARTS (Indicated by Red Circles ) GR-100 GR-200
Handle 1 1
2 Main Body 1 1
Center Leg 1 1
1/2” Side Leg 1 1
1/4” Side Leg 1 1
Balance Support 1 1
Stabilizing Plate 1
Adjustable Spacer 1
HARDWARE (Indicated by Blue Circles ) Red Bag Blue Bag
A #10 x 7/16” OD Washer 8 8 2
B 1/4 x 1/2” OD Washer 2 2
C 9/32” OD O-Ring (#10 screw) Black 6 6 2
D 5/16” OD O-Ring (1/4-20 screw) Orange 2
E 10-32 x 1/2” Thumb Screw 2 2 2
F 10-32 x 5/8” Thumb Screw 2 2
G 1/4-20 Oval Nut 2 2
H 10-32 Offset Oval Nut 2 2
K 1/4-20 x 3/4” Pan Head Screw 2 2
L 10-32 x 1/2” Pan Head Screw 4 4
M 1/4-20 x 1 3/4” T-Bolt 2
N 1/4-20 Thumb Knob 2
P Nylon Shoulder Washer 2
GR-100 GR-200
NOTE: Please check if you have all the parts
and hardware before assembling.
If you have purchased the GRR-RIPPER Upgrade Kit
(GRAK-404) please reference Step 6 on Page 10 for
installation instructions.
7
2
8
4
3
5
6
1
Figure 4
A
1
A
1
4
2
5
7
3
6
8
C
B
D
E
F
G
H
K
L
M
N
P