Hardware manual

Quick Start Guideline XV-2xx Systems MICRO PANEL
Commissioning of the Unit
3.4 ETHERNET
The Ethernet interface of the unit is used for engineering the visualization “GALILEO” as also
programming the PLC with “MXpro”. To commission the communication between the unit and the PC
follow the next described steps.
An IP-Address always consists out of a network and computer address. The network mask specifies
which bits belong to the network and which do not.
Select for the unit a free computer address from
the local network. You can determine the network
address of your PC under start
Æ setting Æ
network and telecommunications connections
Æ
properties
Æ characteristics. Select out of the list
Internet protocol (TCP/IP) and press the button
properties.
Setting of the network card of the PC
Example:
IP-Address PC:
IP-Address : 192.168.0.71
SubNetMask : 255.255.255.0
This means:
Network-Address : 192.168.0
Computer-Address : 71
Select an IP-Adresse for the unit:
Network-Address : 192.168.0
Computer-Address : 72 (Number between 1-254 and not any already used in
the local network)
Æ IP-Address unit:
IP-Address : 192.168.0.72
SubNetMask : 255.255.255.0
Attention
The usage of the same address twice can cause critical network problems!
10
Subject to technical changes
M001789-01.DOC
© by Micro Innovation