Micro Webcam Matrix Users Manual
FCC STATEMENT IC445C This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of FCC Rules.
TABLE OF CONTENTS WELCOME…………………………………………………………........ INSTALLING THE CAMERA…………………………………............. TROUBLESHOOTING AND TECHNICAL SUPPORT……………... HELPFUL HINTS……………........................................................... WARRANTY INFORMATION………………………………...............
Welcome Congratulations on the purchase of your new Micro Innovations Webcam Matrix. This manual will help guide you through the setup process and answer any questions you may have regarding your webcam .
INSTALLING THE CAMERA NOTE: Please insert the CD-ROM and install the driver and software before plugging in the camera! Software Installation STEP 1 - Insert the CD into your CD-ROM drive. The Setup Wizard will appear on your computer screen. Note: If the Setup Wizard does not appear, click Start and select Run. Type :\Setup and press Enter. (Example: if the disk is in drive D, you would type D:\Setup) STEP 2 – Follow the onscreen instructions to install the driver and software applications.
Hardware Installation STEP 1 - Insert the USB connector into an available USB port or hub located on your computer. STEP 2 – A Found New Hardware wizard will appear. Follow the onscreen instructions, clicking Next to install the hardware. Note: If you are installing this device running Windows XP, you may encounter a notification stating that this device has not passed Windows XP Logo Testing. Select Continue Anyway to complete the installation.
Troubleshooting • If your camera is not recognized in Windows, be sure to check that the USB connector is securely connected into the back of your computer. You may have installed the driver with the camera plugged in. Uninstall the driver, unplug the camera, and then reinstall the driver. Then reinstall the camera hardware as directed in the Hardware Installation section. • You may have connected your camera while the computer was turned off.
Helpful Hints The following hints will help you achieve the best results with your Micro Webcam Matrix: Camera placement • • Position the camera so that the subject is centered. Place the camera on a steady surface. Lighting • • • Use sufficient lighting. Place the light source behind the camera and facing the subject. Maintain a consistent lighting environment, i.e. do not mix fluorescent lighting and other lighting types.
Focus • For a sharper image, adjust the focus of your Micro Webcam Matrix by rotating the focus ring located on the front of your camera. Maintenance • Keep the camera away from moisture and extreme temperature. • Never use harsh or abrasive cleaners or organic solvents on the camera or on any of its parts. • Never disassemble or touch the inside of the camera. To Clean Your Camera Lens • Blow gently on the lens to remove any dust and/or dirt.
WARRANTY INFORMATION Charge to the purchaser for parts or labor for the time periods. This warranty does not apply to a ny appearance items of the product nor to the additional excluded item set forth below nor to any product the exterior of which has been damaged or defaced which has been subjected to misuse, abnormal service or handling or which has been altered or modif ied in design or construction. The limited warranty described herein is in addition to law.
