User manual

Microgate Srl P. 65 / 74
3.4.7 CONFIGURE WITTY·RFID
This process is similar to configuring the photocells (chap. 3.4.5). Put Witty·RFID in configuration mode (when
off, hold down the On/Off button for 5 seconds) and connect it to the PC. Change the parameters and press
ENTER.
For a detailed explanation of the radio channels and the radio power, please refer to the Kit manual in chapter
5.4.1.2 and 5.4.1.3
3.4.8 WITTY RFID FIRMWARE UPDATE
This function is similar to the update for the photocell firmware (chap. 3.4.6). Connect Witty·RFID when
OFF and press the button <Update Witty·RFID Firmware>.
3.4.9 CONFIGURE WITTY·SEM
This process is similar to configuring the photocells (chap. 3.4.5). Put Witty·SEM in configuration mode (when
off, hold down the On/Off button for 5 seconds) and connect it to the PC. Change the parameters and press
ENTER.
The address (from A to H) is used to assign an address to Witty·SEM that must be different from the other
ones; in practice, if 4 traffic lights are available, in order to carry out the Agility exercises correctly, they must
be configured as A, B, C, D.
3.4.10 WITTY SEM FIRMWARE UPDATE
This function is similar to the update for the photocell firmware (chap. 3.4.6). Connect Witty·SEM when OFF
and press the button <Update Witty·SEM Firmware>.