User manual

Microgate Srl P. 62 / 74
3.4.6 CONFIGURE WITTY PHOTOCELL
This function allows to change some settings of a photocell which is connected via USB. Proceed as follows:
 Turn off and (if connected) disconnect the photocell from the PC.
 Press and hold the Power key for 5 seconds, until the LED turns red and blinks.
 Connect the photocell with the PC by means of a USB cable.
o The settings are displayed, as well as the serial number, and the firmware version.
 Press the <Configure Witty Photocell> key.
 Change the settings accordingly (see the following chapters for further information).
 Press the <Send> key
o A confirmation message is displayed.
 Disconnect the USB cable.
o The photocell restarts and is turned on with the new settings.
All settings (except the channel) can be reset to default using the "Reset Default" function from the Witty
timer (see chap. 5.4.1.2 of the Kit manual).
3.4.6.1 RADIO CHANNEL, PHOTOCELL MODE AND RADIO POWER
For a detailed explanation, please refer to the Kit manual in chapter 5.4.1.2 or 5.4.1.3.