Specifications
MICRO
EQ
cont'd
position,
the
bandwidth
is
2
octave
while with the switch
in the
depressed
position,
the
bandwidth
is
ll2octave.
The Mid Freq Select
(the
outer
ring
of the
dual concentric
knob)
allows
you
to select any
frequency between
250 Hz and 6kHz.
The Mid
Freq Level
(the
inner
ring
of the
dual concentric
knob)
allows
you
to either
boost or attenuate
any
frequency selected
by
the
Mid
Freq
Select
knob
up to
a
maximum of
+15d8.
The Mid
Freq Width operates
identically to the
Lo
Freq Width
switch.
The Hi
Freq
Select
(the
outer
ring
of the
dual concentric
knob)
allows
you
to select
any
frequency between
1.5k
and
20kHz.
The Hi Freq
Level
(the
inner ring
of
the dual
concentric
knob)
allows
you
to either
boost or attenuate
any
frequency
selected
by
the
Hi
Freq
Select
knob
up to
a
maximum of
t15dB.
The Hi Freq
Width
operates
identically to the
Lo
Freq Width
switch.
The
Clip
LED lights when the
MICRO EQ
is
being
fed
too
hot
a
signal,
and therefore
overloaded.
When this occurs,
turn
down the
Input control
until the Clip
LED no
longer
fires.
Operation
The
best
way to use
your
MICRO EQ
is
as
follows:
1.
Start
by turning the
Level control of
the desired
frequency
band
(low,
mid,
or
high)to maximum.
2. Sweep the
frequencies with
the
Frequency Select
knob
until
you
find
the
frequency
that
you
wish
to
cut.
(lf
the Clip
LED
should
light, turn down
the Input control).
3.
Now, back off the
Level control untilthe
new amplitude
results
in
a
pleasing
sound.