User manual

Microgate MicroGraph LED User Manual Page 6 of 88
1.1 CONTROL PANEL
Figure 2 – Control panel
RADIO: 5-pole Nucletron connector for
Linkgate radio system connection
WLAN: WiFi aerial connector (optional)
LOW BATTERY: Battery status signal LED.
SERIAL1: 6-pole Amphenol connector for serial
input/output
SERIAL2: 6-pole Amphenol connector for serial
input/output
START STOP LAP INPUTS: 6-pole Amphenol
connector for START, STOP, and LAP signals
FUSE: Fuse cavity
SPEAKER: Jack connector for external speaker
connection
START STOP: Green START STOP button used
for manual START and STOP signals and for
modifying values in program settings
1
LAP RESET: Yellow LAP RESET button used for
manual LAP signals and for confirming program
settings
2
POWER: On/Off switch
SUPPLY: Neutrik connector for external power
supply and battery charging (if used)
ETHERNET: Ethernet network cable connector
USB: USB cable connector for firmware
updating
1
This button will hereafter be referred to as
START-MODIFY
2
This button will hereafter be referred to as
LAP-SETUP