User manual

Microgate MicroGraph LED User Manual Page 52 of 88
2.18 ATHLETIC
This program has been studied for managing base information for track-and-field competitions.
After choosing the program you must indicate which one of the 3 types is to be used:
2.18.1.1 SETUP
Keep the LAP-SETUP button pressed for at least 2 seconds to enter the Setup. Press START-MODIFY to change
the displayed values.
Configuration
Counter| Countdown| Wind Set the mode with START-MODIFY:
Press LAP-SETUP
2.18.2 COUNTER
Pressing the green START key, the number of laps increases by one unit. Pressing the yellow RESET
key, the number of laps decreases by one unit. After reaching the maximum lap number (999) the
value is reset to 0.
2.18.3 COUNTDOWN
Pressing the green START key, the countdown starts. To stop the chronometer just press the green
START key and, to restart it, press the green START key again. The yellow RESET key resets the
countdown. When the set time is finished, the display board displays the writing ‘OUT’. To go back
to the initial condition just press the yellow RESET key.
2.18.3.1 SETUP
Keep the LAP-SETUP button pressed for at least 2 seconds to enter the Setup. Press START-MODIFY to change
the displayed values.
MM
0 Set the minutes of countdown start time.
Press LAP-SETUP
SS
30 Set the seconds of countdown start time.
Press LAP-SETUP