User manual

Microgate MicroGraph LED User Manual Page 41 of 88
2.9 LAP TIMER
The Lap Timer program allows you to time lap times. At each Start or Stop pulse (indifferently) the
chronometer detects the time from the previous impulse and restarts automatically from zero. Time
continues to be displayed for 8 seconds, and then the running time appears again. The input and Lap key
reset the chronometer to zero.
RADIO: As well as giving the manual or input START, STOP, and LAP signals, a Linkgate radio system can be
used (after correctly setting the radio channel in the General Setup). The display board accepts LAP signals
(of any kind).
2.9.1 SETUP
It is possible to set the starting and the deactivation time of inputs after a pulse (hold-off time).
Keep the LAP-SETUP button pressed for at least 2 seconds to enter the Setup. Press START-MODIFY to change
the displayed values.
Advanced Setup ? Press any key to continue.
Yellow = Yes Press LAP-SETUP to enter the general setup (see par. 2.1)
Green = No Press START-MODIFY to scroll the setup of the current program
Start Time
HH = 0 Set the time with START-MODIFY
Press LAP-SETUP
Start Time
MM = 0 Set the minutes with START-MODIFY
Press LAP-SETUP
Start Time
SS = 0 Set the seconds with START-MODIFY
Press LAP-SETUP
Start Time
mm = 0 Set the thousandths with START-MODIFY
Press LAP-SETUP
Autoreset
Time= 0 Set the automatic Reset time (in seconds). After a stop command and when
the above-stated time has passed, the chronometer is reset to zero. An
invalid (zero) time disables the Autoreset function.
Press LAP-SETUP
Holdoff
SS = 0 Set the seconds with START-MODIFY
Press LAP-SETUP