User manual

Microgate MicroGraph LED User Manual Page 34 of 88
2.5.1 SETUP
It is possible to set the length of the measurement base, the speed unit, the minimum and
maximum speed allowed, the mono or bidirectional mode and the delay with which the display
program is automatically activated.
Keep the LAP-SETUP button pressed for at least 2 seconds to enter the Setup. Press START-MODIFY to change
the displayed values.
Advanced Setup ? Press any key to continue.
Yellow = Yes Press LAP-SETUP to enter the general setup (see par. 2.1)
Green = No Press START-MODIFY to scroll the setup of the current program
Speedbase Length ? Press LAP-SETUP
Speedbase
KM = 0 Set kilometers by pressing START-MODIFY
Press LAP-SETUP
Speedbase
M = 0 Set meters by pressing START-MODIFY
Press LAP-SETUP
Speedbase
CM = 0 Set centimeters by pressing START-MODIFY
Press LAP-SETUP
Set Speed Unit
KMH | MPH | KNT | M/S Set unit by pressing START-MODIFY (it is possible to choose between
kilometers/hour, miles/hour, knots, and meters/second)
Press LAP-SETUP
MIN Speed
3 KMH Set minimum speed by pressing START-MODIFY
Press LAP-SETUP
MAX Speed
0 KMH Set maximum speed by pressing START-MODIFY
Press LAP-SETUP
Bidirectional=
0 Set bidirectional mode by pressing START-MODIFY (0=No 1=Yes)
Press LAP-SETUP
Program Delay
MM= 0 Set the number of minutes after which the user program no. 1 should start
with START-MODIFY
Press LAP-SETUP