User manual

Microgate MicroGraph LED User Manual Page 30 of 88
2.4 TIMER (CHRONOMETER)
In this mode MicroGraph works as a typical 1/100 second precision chronometer.
• Pressing Start (manual, from input or via radio) the chronometer begins to count.
• With Lap (manual, from input or via radio) the chronometer displays an intermediate
time for 5 seconds.
• The chronometer is stopped using the manual Start/Stop or via radio.
• At this point it is possible to reset the chronometer with a further Lap.
Without reset the chronometer starts from the displayed value.
If the AutoReset time has been set, after each Stop (or manual Start) the chronometer is reset
after a given amount of time.
RADIO: The Timer program can be used also with a Linkgate radio system once the radio channel
has been set correctly. The MicroGraph display board works also with START, LAP, and STOP
signals from Linkgate.
2.4.1 SETUP
Keep the LAP-SETUP pressed for at least 2 seconds to enter the Setup. Press START-MODIFY to change the
displayed values.
Configuration
Normal | Over 24H | Until 24H Set the desired mode:
Normal = the chronometer starts from 0:00
Over 24H = the chronometer continues infinitely and after 24h displays
time as 24:00:01
Until 24H = the chronometer stops after 24h.00.00
Press LAP-SETUP
Advanced Setup ? Press any key to continue.
Yellow = Yes Press LAP-SETUP to enter the general setup (see par. 2.1)
Green = No Press START-MODIFY to scroll the setup of the current program
Set Starttime
HH= 0 Set the hours
Press LAP-SETUP
Set Starttime
MM= 0 Set the minutes
Press LAP-SETUP
Set Starttime
SS= 0 Set the seconds
Press LAP-SETUP