User manual

Microgate MicroGraph LED User Manual Page 25 of 88
2.1 GENERAL SETUP
Enter the Setup menu of a program (if available) by pressing the yellow LAP-SETUP button for 3
seconds. Once concluded the program configuration the so-called 'Advanced Setup' is displayed,
i.e. the possibility to change the general parameters of the display board applied to all programs.
When Advanced Setup is displayed, press any button and confirm pressing LAP-SETUP to enter the
menu.
The values available for each menu item can be scrolled down with the green START-MODIFY button
and are confirmed by pressing the yellow LAP-SETUP button:
Brightness Type
AUTO | MANUAL Set the brightness type. Automatic uses the brightness sensor, whereas
Manual uses the level set in the following step
Brightness
1…100% If Brightness Type = MANUAL, set brightness with START-MODIFY. Holding the
button, the numbers increase rapidly
µGraph PIX Emulator
YES | NO Enable / Disable emulation of Micrograph PIX
Radio Channel
0…127 Set the same radio channel as the one set on Linkgate
IP Address
x.x.x.x Set the IP Address of the connected Ethernet board. The address must be a
valid IP from 0.0.0.0 to 255.255.255.255. Press LAP-SETUP to toggle between
the 4 groups of numbers.
Wireless
YES | NO If the display board is equipped with a WiFi board, turn on or off the
wireless device. The items below are available only if Wireless = YES
Wireless IP Address
x.x.x.x Set the IP Address of the WiFi board. The address must be a valid IP from
0.0.0.0 to 255.255.255.255. Press LAP-SETUP to toggle between the 4 groups
of numbers.
WiFi Networks
[SSID name] All wireless networks detected within the WiFi range. If no networks are
displayed ('No Networks!' message), make sure that the antenna of the
connector has been connected and try to change its inclination slightly.
Choose the network that you want to connect to by pressing LAP-SETUP.
Wireless key
x.x.x.x If the WiFi network is WEP or WPA/PSK protected, enter the access key
(password). Press START-MODIFY to scroll down the letters/numbers of the
alphabet and then press LAP-Setup to confirm and go to the next letter.
Given the intrinsic difficulty of this operation, we suggest that you set the
password via the Microgate software.