User manual

Microgate MicroGraph LED User Manual Page 21 of 88
1.7 FIRMWARE UPDATING
Each time MicroGraph is turned on, it displays the firmware version presently stored, usually with
the following syntax: x.y.z (major, minor, revision).
Figure 25 - Firmware version
The firmware can be updated downloading it from the SUPPORT section of the www.microgate.it
website.
Once downloaded the file, please follow the steps below:
 Turn on the display board and wait until boot is complete.
 Connect the USB cable (not supplied) from the display board to a USB port of your PC.
 Launch the Updater program following the on-screen instructions. In particular, if the
software does not detect Active Sync (for Windows XP) or Windows Mobile Device Center
(Vista/Windows 7), it suggests a link for downloading and installing it.
 Select the option 'Keep existing settings' to maintain all current settings; if you do not
select it, the default values are restored.
 After a few minutes the display board is reset automatically displaying the number of the
new installed version.
Figure 26 – Updater Software