User manual

Microgate MicroGraph LED User Manual Page 14 of 88
The power supply and data connection is done by pulling out the light blue supply connector and
the serial cable with Amphenol connector, and connecting them respectively to the supply input
and the Serial 1 banana jack of the next display board.
Figure 10 - Power supply and data connection
Now let's see how two display boards are connected horizontally and vertically.
NOTE: BEFORE assembly, carry out the row and column configuration for each display board
(par.2.2.1, Row and Column Parameters). Alternatively, after assembly, using the Microgate
software or another third-party software implementing our protocol, use the AutoConfig
commands (par. 3.1.2).