Specifications

Start Up

Please install at first the software TIM Connect from the CD, as described in the next chapter. The CD

contains the software application as well as the unit specific calibration data. These data will be installed

also automatically.

Now you can connect the infrared imager to a free USB port (USB 2.0) of your PC.

After the software has been started, you should see the live image from the camera inside a window on your

PC screen.

In case you are using more than one TIM simultaneously go to Devices to select required TIM from the list.

The sharpness of the image can be adjusted by turning the exterior lens ring.

Fig. 6.1 Initiating phase after starting TIM Connect software

thermoIMAGER TIM 16