User`s manual

7
MICRO-D Full Manual V.1.2
1 Sensor-in / Alarm-out
The sensor terminal block is used to connect a sensor such as PIR to the MICRO-D. If you add motion
sensor devices to your MICRO-D, the video recording can be triggered by event.
The alarm output terminal is used to install a single alarm device.
2 SD Memory Slot
Insert SD Card into the slot for storing data.
3 Recording LED
This light indicates while MICRO-D is on recording mode.
4 Status LED
This light blinks when events occur or there is any error..
5 Power LED
This light indicates the MICRO-D is powered up.
6 Remote control Receiver
When controlling MICRO-D by remote control, be sure to point at the receiver.
7 Reset
Press the reset button if you want to return setting values to the default.
8 AV-IN
Connect AV-IN connector
9 AV-OUT
Connect AV-OUT connector
10 Power
Connect 12V power supply in the package.