User`s manual

MICRO-D Full Manual V.1.2

5.1.4 ALARM CONTINUE: Regardless of post recoding time, recording triggered by EVENT (Alarm and Motion)

continues during event max.30 Min. For example, the alarm recording is continued until the N.O. circuit becomes

open again.

5.2 MOTION DETECTION

5.2.1 SENSITIVITY (LOW / NORMAL / HIGH): You can select the degree of sensitivity of motion detection.

Set to HIGH for greater sensitivity to small movements.

5.3 SCHEDULE SETUP

Make schedule for the recording time. Up to 4 schedules can be set.

5.3.1 TIME: Start to record when scheduled recording time is up.

5.3.2 TIME & EVENT: to record when motion is detected or an alarm occurs within scheduled period.

6. SUB MENU

6.1 PASSWORD CHANGE

The Factory Default Password is 0000. To

enter this number, press the UP, DOWN

button on the remote control. Once you input

the current password, set a new four digit

password using the buttons UP, DOWN on the

remote control. Then, confirm your new

password by entering the number again. *

PASSWORD ENABLE: ‘NO’

Select ‘NO’, if you want to enter the OSD

MENU without Password.

6.2 FILE INDEX RENEW

The index file is automatically generated and

stored in the SD card when inserted into

MICRO-D. If the index file does not match the

files actually stored in the SD card, users can

synchronize the index file list and the actual

file list. While synchronizing, the process

percentage is displayed; on completion the

value returns to ‘NO’.

YES

30 MB

125 MB

Yes

112 MB

480MB

Yes

112 MB

480MB