User`s manual

7
MICRO-D Manual V.1.3
1 Sensor-in / Alarm-out
The sensor-in is installed to connect Sensor Terminal Block on the main body of MICRO-D and alarm
activates when event occurs. If you add motion sensor devices to your MICRO-D, the video recording
can be triggered by event. The alarm output terminal is used to install a single alarm device.
2 SD Memory Slot
Insert or remove the SD CARD.
3 Recording LED
GREEN LED turns on during Recording mode.
4 Status LED
STA LED turns on when Event occurs or Error.
(Recording Mode: GREEN LED ON & ORANGE LED BLINK, Error: ORANGE LED BLINK)
5 Power LED
RED LED turns on when power is up.
6 Remote control Receiver
When controlling MICRO-D by remote control, be sure to point at the receiver.
7 Reset
Product returns to default value.
8 AV-IN
AUDIO/VIDEO INPUT PORT
9 AV-OUT
AUDIO/VIDEO OUTPUT PORT
10 Power
12V POWER INPUT PORT