Troubleshooting guide

MAGNUM VERSION 8 MANUAL REVISION 3.1
9
12-09-11 BWW
 Rev 2.5
 Corrected section 7.60 MDP EXV Logic
 Corrected section 13.2 Magnum Setpoints - Setpoint #205 “MDP MIN OIL DIFF”
06-24-12 MAS
 Rev 2.6
 Updated section 13.2 Magnum Setpoints - Setpoint #99 “LLS#3 ON (ECONOMIZER)”
Setpoint #84 “LO DISC SHEAT”
Setpoint #4 “HGS TEMP ON”
Setpoint #5 “HGS TEMP OFF”
Setpoint #143 “UNLOADED %”
 Added section 7.7.6.4. Excess Purge Logic
 Updated Hardware
11-26-12 MAS
 REV 2.7
 Updated section 13.2 Magnum Setpoints - Setpoint #33 “MIN ADJUST%”
Setpoint #56 “PULSE DELAY”
Setpoint #105 “PUMP FAILURE”
Setpoint #147 “PROC ZONE”
Setpoint #148 “PROC DELY”
Setpoint #149 “PROC MAX ROC”
 Updated Micro Control System’s Address
01-07-13 MAS
 REV 2.8
 Updated section 13.2 Magnum Setpoints - Setpoint #35 “AMP DB HI”
Setpoint #36 “AMP DB LO”
Setpoint #61 “PMP DWN OFF”
 Updated section 7.39.1. Economizer Set up
 Updated Authorization Function
02-13-13 MAS
 REV 2.9
 Updated section 13.2 Magnum Setpoints - Setpoint #45 “CND STG1 ON”
Setpoint #46 “CND STG1 OFF”
Setpoint #47 “CND DIFF ON”
Setpoint #48 “CND ADJ DELAY”
Setpoint #48 “CND DIFF OFF”
Setpoint #48 “DUAL PSI DELTA”
Setpoint #49 “CND START %”
Setpoint #49 “CND MIN RUN”
Setpoint #49 “DUAL TIME DELAY”
Setpoint #50 “CND TRGT”
Setpoint #50 “LO AMB SUMP OFF”
Setpoint #51 “CND ADJ DIV”
Setpoint #51 “CND VFD MIN”
Setpoint #52 “CND MIN %”
Setpoint #53 “CND ROC”
Setpoint #54 “CND ADJ MULT”
Setpoint #54 “CND MIN SPD”
Setpoint #55 “CND MIN ADJ”
Setpoint #55 “CND MAX SPD”
Setpoint #90 “CND FAULT”
Setpoint #130 “CmpSpdUnld%”
Setpoint #131 “CmpSpdLoad%”
Setpoint #193 “CND HI/LO ZONE”
Setpoint #194 “CND 2
nd
ZONE"
 Updated Section 7.73. “Condenser Control Logic”
04-04-13 MAS
 REV 3.0
 Updated section 7.73.3.9. Modulating Condenser
 Updated section 13.2 Magnum Setpoints - Setpoint #3 “CTL ZONE –”
Setpoint #30 “MAX SLIDE %”
Setpoint #31 “MIN SLIDE%”