Troubleshooting guide

MAGNUM VERSION 8 MANUAL REVISION 3.1
17
4.2. HVAC STATUS Display (MCS-Connect)
The screenshot above shows the following features:
 The top row of buttons provides function selection within MCS-Connect.
 The authorization level button is located in this row; it will automatically update to display the current
authorization level. The example above is at a factory level authorization.
 Just below the top row of buttons, there is a row of tabs. The first is the Site Information screen which will
show you details of all the Magnum controllers available to establish a connection, the remaining tabs allow
you to access to each one respectively.
 There are four quadrants of information displayed for each Magnum controller, namely: Relay Outputs, Analog
Outputs, Sensor Inputs, and Unit Status (with six sub-menus of Status, Alarms, Setpoints, Reset/Clear,
Schedule, and Service). Note: these screens may not always be displayed in the same position; MCS-
Connect will automatically adjust the screen arrangement for optimum display information.
The status of the Capacity Control States, Compressor Control States and EXV Control States can be viewed from
MCS-Connect by clicking the “Status” screen in the Unit Status quadrant. The following screen will be displayed:
Function
Buttons
Unit Tabs
Relay
Outputs
Analog Outputs
Unit Status
Sensor Inputs