Troubleshooting guide

MAGNUM VERSION 8 MANUAL REVISION 3.1
133
If you are going to manually assign the IP Address, Subnet Mask, and Default Gateway.
 Press the Menu key, select Serv Tools, and then press the Enter key.
 Select Ethernet Network then press Enter.
 Set “DHCP Enabled” to NO.
 Set the “IP Address”.
 Set the “Subnet Mask”.
 Set “Default Gateway”.
If you are going to let your network assign the IP Address, Subnet Mask, and Default Gateway:
 Press the Menu key, select Serv Tools, and then press the Enter key.
 Select Ethernet Network then press Enter.
 Set “DHCP Enabled” to YES.
 Connect the MCS-Magnum to the network and power up the board.
Johnson N2 11.11.4.
The N2 address can be verified and changed (with the proper authorization code) from the keypad/LCD.
 Press the Menu key, select Serv Tools, and then press the Enter key.
 Select RS485 Network then press Enter.
 Select Protocol then press Enter. Change the protocol to N2.
 Select address then press Enter. Change the address then press Enter.
 Select Baud then press Enter. Set the baud rate then press Enter.
 Connect the communication wires to the TX RS485 three-position terminal located above the Ethernet
connector.