Specifications

5
Installation:
Inspection:
The Micro-Air Dust Collector is shipped on one
skid. The skid should be inspected for any visible
damage that may have occurred during shipment.
One skid is the blower motor, collector cabinet,
Dust collection Tray/Hopper, Mounting Legs.
Additional equipment that may be shipped
includes:
Leg Cross Bracing Kit
55 Gallon Barrel Lid Kit
Inlet Plenum with (4) 14” x 14” Inlets
Discharge Silencer
Hepa After-Filter Kit
Photohelic Kit
Remote Start/Stop Station
Equipment/Tools Required:
Equipment and tools needed for proper installation
will include the following:
Crane or Lift Truck
Lift Straps or Chain
1/2” Scocket Wrench
Pipe Wrench
Assembly of Unit:
1. Determine the location where the unit is to be
installed. Be sure to allow suffi cient room to
access the unit for servicing and maintenance
on all sides.
2. Lift the unit with a lift truck or overhead
crane using the four lifting lugs located at the
corners of the unit (see Figure 1).
NOTE: Each lifting strap or chain should be rated
for 2000 lb. The chains located on the motor
side should be 10 inches shorter that the chains
on the fi lter side to properly balance the unit
while lifting. Recommended chain lengths are as
follows.
Front side 48 inches
Motor side 38 inches
FIGURE 2
FIGURE 1
CAUTION: THE UNIT SHOULD BE LIFTED
OFF THE SKID AND SET INTO POSITION BY
UTILIZING THE LIFTING LUGS PROVIDED.
SEVERE DAMAGE MAY RESULT FROM ANY
OTHER LIFTING METHOD.
3. Bolt on the four legs. The two lower bolts at each
corner will be removed and used to attach each
leg (see Figure 2).
CAUTION: THE UNIT SHOULD BE LIFTED
OFF THE SKID AND SET INTO POSITION BY
UTILIZING THE LIFTING LUGS PROVIDED.
SEVERE DAMAGE MAY RESULT FROM ANY
OTHER LIFTING METHOD.