Specifications

RP DUST COLLECTOR

INLET PLENUM INSTALLATION PROCEDURE

This Kit Includes:

1 ea. 38292-01 RP Inlet Plenum Assembly

1 ea. P3653 Hardware Package - Containing:

4 ea. P261 5/16-18 X 1/4 Bolt

4 ea. P249 5/16” Lock Washer

4 ea. P233 5/16” Flat Washer

24 ea. P2543 1/4” X 1” Self-Tapping Screw

11 ft. P3686 3/16” X 1” Self-Adheasive Foam

INSTALLATION:

1. Remove inlet plenum from skid and inspect for any possible damage incurred during shipping.

2. Place self-adheasive foam on the outside of the inlet plenum hole pattern.

3. Place inlet plenum on top of dust collector and using the four (4) bolts, ﬂ at washers and lock washers

provided to attach the inlet plenum at the four corners.

4. Use the twenty-four (24) self-tapping screws to complete the installation of the inlet plenum..

5. Three cap plates can be removed and reinstalled to allow you to use the opening best suited for your

installation.

FIGURE 12

BOLT

SELF-TAPPING

SCREWS

SELF-ADHEASIVE

FOAM