EasyTouch RV 359 Manual

Operating the Thermostat

Main Screen

This screen is where most time is spent using the

thermostat. This screen allows you to set and

monitor the desired operation of the thermostat

and is shown in Figure 4.

(1) Inside temperature

This is the temperature reading for the space that

the thermostat is trying to temper, determined by a

local sensor. “Inside” means it is using a sensor

inside the thermostat. “Inside(R)” is not used in this

model and should display “Inside”.

(2) Local Weather

This icon indicates the local weather at the last time

weather information was received. Tap the icon for

more detailed weather information. See section

Local Weather and Local Time for more details.

(3) Status Tray

Various icons may be here to indicate active operations.

The Wi-Fi indicator shows the state of the thermostat’s Wi-Fi connection. No icon means

no connection to an internet enabling device. Red means it is connected to an internet

enabling device but does not have internet. Green means it is connected to the internet.

The number of bars indicate strength. See the Connecting to a New Wi-Fi Network for

more details.

The Furnace icon here means that the heat mode is in Gas Heat Override. See section Gas

Heat Override for more details.

The Schedule icon here means that the created schedule is active and will change

operation on that schedule. This is turned on and off in the Settings screens. See section

Schedule Screens for more details.

(4) Status Message

Various messages may be shown here to indicate active operations. See the Status Messages section for

potential messages and their meanings.

(5) Temperature Set Point Adjust

Raise and lower the temperature set-point using the red and blue arrows. This sets the desired

temperature for the space based on the operating mode. All modes are listed in the (7) Operational Mode

section.

Wi-Fi Indicator

Gas Override Active

Schedule Active

Figure 4 – Main Screen