EasyTouch RV 359 Manual

Touchscreen Calibration

The EasyTouch RV touchscreen is calibrated at the factory to accurately interpret your

touch presses. Pressing the Touchscreen Calibrate Button will allow you to recalibrate the

touch press area. Follow the on-screen prompts to calibrate the touchscreen. Any

overlapping test targets on the second screen is a good calibration.

Restart

This setting will turn the thermostat off then on as if removing and restoring power. Tap

the Restart button and follow the on-screen prompts to confirm.

Reset All

This setting will reset certain settings in the thermostat back to factory defaults. Some

thermostats offer options to which settings to return to defaults. Tap the Reset All button

and follow the on-screen prompts to choose what you would like to reset.

Dip Switches

This setting is used to configure your thermostat’s operational settings and is slightly

different for each EasyTouch RV model. Some simply display how the air conditioner

control board that EasyTouch RV communicates with is configured. Others allow for

telling EasyTouch RV what appliances it has connected to it. Tap the Switches button to

see what configurations are available. See section Thermostat Setup for details on what

must be configured, if any. Micro-Air cannot assist with manipulating and adding more

appliances to your system.

Auto-Generator Start (AGS)

This setting allows for a generator to start prior to any appliances that need line voltage

to run, then turns it off when the cycle completes. Tap the AGS Enable button to green to

enable this behavior or to gray to disable it.

Furnace/Aqua Icons

Most RV systems have auxiliary heat modes in the form of a gas furnace or hydronic heat.

EasyTouch RV or the associated control board treats these as the same output and so you

can tap the Furnace/Aqua button to toggle between what icons to display for this

operational mode. This is simply a cosmetic setting for all EasyTouch RV models except

the 350 model, which should be set appropriately.

Touchscreen

Calibrate Button

Restart Button

Reset All Button

Switches Button

AGS Enable Button

Furnace/Aqua

Button