EasyTouch RV 359 Manual

ManualsBrandsMicro-Air ManualsSolar & Wind PowerWhite - EasyTouch RV Thermostat

Furnace Only or Aqua Only Mode

This mode only runs an auxiliary heating cycle to maintain the heating set-

point in the space. Set the (7) Operational Mode button to Furnace Only or Aqua

Only and the desired (8) Fan Speed, where behavior will then be based on Table 4.

See section Furnace/Aqua Icons for details on the auxiliary heating icon.

Environment (°F)

Cycle Operation

Auto Fan Operation

Inside ≥ Setpoint

None

Off

Inside 1° Or More Below Setpoint

Auxiliary Heat On

Inside Returns 1° Above Setpoint

Auxiliary Heat Off

Table 4 - Furnace Only Mode Operation

Note: Table 4 operation may be different based on the Gap settings. See section Temperature Gap

(Hysteresis) for details.

Auto Modes

These modes will automatically switch between

heating and cooling cycles as needed. Their operation will

be the same as their “only” mode counterparts described

earlier in the Operational Modes section. Auto modes will

have their own “dual” set-points that are separate heating

and cooling set-points. No heating or cooling cycles will

occur when the inside temperature is between the set-

points.

This can be useful when setting a higher day-time

cooling temperature and lower night-time heating

temperature. It can also be used to control the

temperature extremes when you are away from the RV.

Figure 5 shows how the main screen will look in auto mode.

Note: These auto modes are subject to Gas Heat Override

and Gap operations. See their Gas Heat Override and

Temperature Gap (Hysteresis) sections respectively for

more details.

(1) Auto Mode Set-Points

Press the set-points to toggle between which set-point you

have selected. A blue square will show around the one you

have selected. The upper set-point is for cooling and the

lower set-point is for heating.

(2) Set-Point Adjustment

Use the up and down arrows to change the selected set-point value.

Furnace Only Mode

Figure 5 - Auto Mode Main Screen

Auto Cool/Heat Pump Mode

Auto Cool/Furnace Mode

Aqua Only Mode

Auto Cool/Aqua Mode