EasyTouch RV 359 Manual

ManualsBrandsMicro-Air ManualsSolar & Wind PowerWhite - EasyTouch RV Thermostat

Operational Modes

All modes operate the overhead fan and/or a heating or cooling cycle based on the current

heating or cooling setpoint, relative to the inside temperature.

Fans and Fan Only Mode

This mode lets the fan to operate based on the chosen (8) Fan Speed.

This will circulate the air without operating any heating or cooling cycles.

Cool Only Mode

This mode only runs a cool cycle to maintain the cooling set-point in the

space. Set the (7) Operational Mode button to Cool Only and the desired (8) Fan

Speed, where behavior will then be based on Table 2.

Environment (°F)

Cycle Operation

Auto Fan Operation

Inside ≤ Setpoint

None

Off

Inside 1° Above Setpoint

Cooling Cycle Begins

On Low

Inside 3° Or More Above Setpoint

Cooling Cycle Continues

Low or High Based on Gap

Inside Returns 1° Below Setpoint

Cooling Cycle Terminates

Runs 30 More Seconds, Off

Table 2 - Cool Only Mode Operation

Note: Table 2 operation may be different based on the Gap settings. See section Temperature Gap

(Hysteresis) for details.

Heat Pump Only and Heat Strip Only Mode

This mode only runs an electric, overhead, heat pump or heat strip

heating cycle to maintain the heating set-point in the space. Set the (7)

Operational Mode button to Heat Pump Only or Heat Strip Only and the desired

(8) Fan Speed, where behavior will then be based on Table 3.

Environment (°F)

Cycle Operation

Auto Fan Operation

Inside ≥ Setpoint

None

Off

Inside 1° Or More Below Setpoint

“Electric” Heat Cycle Begins

On low

Inside 3° Or More Below Setpoint

“Electric” Heat Cycle Continues

Low or High Based on Gap

Inside Returns 1° Above Setpoint

“Electric” Heat Cycle Terminates

Runs 30/90 More Seconds, Off

Table 3 - Heat Pump and Heat Strip Only Mode Operation

Note: Table 3 operation may be different based on the Gap settings. See section Temperature Gap

(Hysteresis) for details.

Note: These heat modes are subject to Gas Heat Override Operation when enabled. See section Gas

Heat Override for details.

Fan Only Mode

Fan Speed

Cool Only Mode

Heat Pump Only Mode

Heat Strip Only Mode