EasyTouch RV 357 Manual

The EasyTouch 357 model thermostat was designed to replace certain Dometic™ multi-zone

capable thermostats. Original thermostats replaced by this model are a five-button configuration with a

display alongside the buttons. If your thermostat is not of this style, please contact Micro-Air

https://www.micro-air.com/SupportRequest to verify the thermostat you received is correct for your

application.

Note: To replace the older four button displays with this thermostat, all air conditioning control

boards must be replaced with the CCC control boards compatible with five button controls.

Installing the thermostat

There are three steps to installing the thermostat. First remove your old thermostat. Next

disconnect and reconnect the wiring. Finally install the mounting pins to the wall and mount your new

thermostat.

Removing the old thermostat

Locate the tab on the center bottom of the thermostat as shown in figure 1. Insert a small screw

driver from the side of the thermostat under the tab and lift the thermostat off from the bottom.

Unplug the thermostat from the cable by pressing the

release tab on the connector. Remove the four back

plate screws and remove the back plate from the wall.

Wiring the thermostat

All models feature a simple telephone style

modular jack. This is a six-pin version of a common

Ethernet connector with a press tab for removing the connector. Press the tab to remove the connector

from the old thermostat and insert it into the new thermostat.

Figure 1