EasyTouch RV 356 Manual

ManualsBrandsMicro-Air ManualsSolar & Wind PowerWhite - EasyTouch RV Thermostat

Operational Modes

All modes operate the overhead fan and/or a heating or cooling cycle based on the current

heating or cooling setpoint, relative to the inside temperature.

Fans and Fan Only Mode

This mode lets the fan to operate based on the chosen (8) Fan Speed.

This will circulate the air without operating any heating or cooling cycles.

Cool Only Mode

This mode only runs a cool cycle to maintain the cooling set-point in the

space. Set the (7) Operational Mode button to Cool Only and the desired (8) Fan

Speed, where behavior will then be based on Table 5.

Environment (°F)

Cycle Operation

Auto Fan Operation

Inside ≤ Setpoint

None

Off

Inside 1° Above Setpoint

Compressor #1 On

On Low

Inside 2° Or More Above Setpoint

Compressor #1 and #2 On

On High

Inside Returns 1° Below Setpoint

Compressors Off

Runs 45 More Seconds, Off

Table 5 - Cool Only Mode Operation

Note: Table 5 operation may be different based on the Gap settings. See section Temperature Gap

(Hysteresis) for details.

Heat Pump Only Mode

This mode only runs an electric, overhead, heat pump heating cycle to

maintain the heating set-point in the space. Set the (7) Operational Mode button

to Heat Pump Only and the desired (8) Fan Speed, where behavior will then be

based on Table 6.

Environment (°F)

Cycle Operation

Auto Fan Operation

Inside ≥ Setpoint

None

Off

Inside 1° Or More Below Setpoint

Compressor #1 And #2 On

On High

Inside Returns 1° Above Setpoint

Compressors Off

Runs 45 More Seconds, Off

Table 6 - Heat Pump Only Mode Operation

Note: Table 6 operation may be different based on the Gap settings. See section Temperature Gap

(Hysteresis) for details.

Note: All heat modes are subject to Auto Gas Changeover Operation when enabled. See section Auto

Gas Changeover in Operating the Thermostat for details.

Furnace Only

This mode only runs an auxiliary heating cycle to maintain the heating set-

point in the space. Set the (7) Operational Mode button to Furnace Only or Aqua

Only and the desired (8) Fan Speed, where behavior will then be based on Table 7.

Fan Only Mode

Fan Speed

Cool Only Mode

Heat Pump Only Mode

Furnace Only Mode