EasyTouch RV 355 Manual

9
©2022 Micro-Air Corp March 15, 2022, revision 1.10
Auto fan
low
N/A
Electric heat, gas
heat
Fan turns on in low
when heat is
running
Auto fan
high
N/A
Electric heat, Gas
heat
Fan turns on in
high when heat is
running
Fan off
N/A
Gas heat
Fan does not turn
on when gas
heating is active
Note: Auto fan speed changes with temperature. More than 1 degree from set point will run the
high fan. The fan will run the low fan speed within one degree of set point.
7. Home-away-schedule icon. Pressing this button selects between these modes. Home mode is
the normal operating mode using a single set point for temperature control. Schedule mode
allows changing set points throughout the day programmatically. Away mode allows setting a
heating and a cooling set point and automatically changing from heating to cooling.
8. The zone selection button will show a zone in green when it is turned on. The zone number will
show in gray if the zone is not available and in red if there is a fault with the zone. A frame will
show around the zone number to indicate it is selected.
9. Pressing the gear will change the settings screen to allow additional setup functions.
10. Pressing the set point will change the system units from °F to °C and back. The set point is also
used as an indicator of system operation. A red set point indicates a heating cycle is in process.
A blue set point indicates a cooling cycle is in process. A white icon indicates no cycle is in
process.