EasyTouch RV 355 Manual

Temperature reading adjustment

Allows changing the internal thermostat sensor calibration. This function works only when “R”

is not displayed after the inside temperature on the main screen. Sensors showing an “R”

indicate the system is using remote sensors located in the air conditioner and they cannot be

adjusted from the thermostat.

Temperature Gap

This sets the difference in temperature before an action will occur. For example, if the set

point is 75° (24°C) and it goes up 1°, the system is in cooling and the gap is set for 1°, the

thermostat will start a cooling cycle. Setting the gap larger will force the thermostat to see 2, 3, or 4

degrees before starting a cycle. This is helpful in preventing short cycling of the heating or cooling

systems. Note: Not available on all thermostat models

Measurement units

Measurement units are labeled Celsius and Fahrenheit for simplicity. Set for Celsius

to use metric units.

Touchscreen Calibrate

This forces a calibrate screen to appear to allow the user to set the touch points on the

screen. Use a blunt pencil or similar implement to touch the four corner markers as they

appear. Use the three diagonal markers to test the calibration. If the circles overlap even a little it is

sufficient to give good touch results.

Restart

The restart icon allows restarting the thermostat as if you powered it off and on again. The

Micro-Air logo will display followed by the main screen. This option can help recover from

certain problems like a lost WIFI connection.

Reset All

This option resets certain settings in the thermostat. Some thermostats offer options to reset

different parts of the memory to factory settings.

Switches

This option varies by thermostat. Some display the settings provided by the remote dip switches

on the control board. Others allow setting some factory options like heating modes. Please see

the Thermostat Setup section to determine actions needed to set up your thermostat.

Generator start

Remote gGenerator start is an option found on some thermostats. Set the icon for the color

version to turn on the generator when a cooling or heating cycle is needed. Set it for gray

when it is not needed.

*Generator start option is not available for the 351, 352, 356, or 359 thermostats.