EasyTouch RV 353 Manual

Once you know which wires match to which, begin by using a small flathead screwdriver (not

provided) or similar to loosen a wire’s associated screw terminal. Slide the wire out of the terminal and

out of the backplate. Ensure that about ½” of insulation is stripped from the end of the wire. Use wire

strippers (not provided) or similar to remove the insulation if needed. Open both levers of a connector

and fully insert this wire in one end and close the associated lever. Do the same to the matching EasyTouch

RV wire. Do this for all four wires.

Warning: Be confident that you are making the right wire connections. Connecting the wires

incorrectly may damage the EasyTouch RV thermostat. Please contact Micro-Air if you are unsure.

Re-apply Power

Restore DC power and the thermostat screen should light up and boot into the main menus.

Restore AC power so that your appliances can run again. Move on to the section Mounting the

Thermostat, or the section Initial Setup Instructions and mount the thermostat later.