EasyTouch RV 353 Manual

Dry Mode

This mode attempts to remove humidity from the space using a set algorithm. Table 7 describes

this algorithm.

Environment

Cycle Operation

Fan Operation

Inside ≤ Setpoint

Compressor ON for 10 minutes

and OFF for 6 minutes

Always Low

Inside > Setpoint

Compressor ON

Table 7 - Dry Mode Operation

Auto Modes

This mode will automatically switch between

heating and cooling cycles as needed. Their operation will

be the same as their “only” mode counterparts described

earlier in the Operational Modes section. Auto modes will

have their own “dual” set-points that are separate heating

and cooling set-points. No heating or cooling cycles will

occur when the inside temperature is between the set-

points.

This can be useful when setting a higher day-time

cooling temperature and lower night-time heating

temperature. It can also be used to control the

temperature extremes when you are away from the RV.

Figure 2 shows how the main screen will look in auto mode.

Note: Auto mode is subject to Gap operations. See section

Temperature Gap (Hysteresis) for more details.

(1) Auto Mode Set-Points

Press the set-points to toggle between which set-point you

have selected. A blue square will show around the one you

have selected. The upper set-point is for cooling and the

lower set-point is for heating.

(2) Set-Point Adjustment

Use the up and down arrows to change the selected set-point value.

Figure 2 - Auto Mode Main Screen

Auto Mode