EasyTouch RV 350 Manual

6. Pressing the fan icon selects between manual (always on) fan speeds and automatic fan speeds.

Automatic will turn the fan off after the heating or cooling cycle is completed. See table 3 for

available fan speeds.

Table 2

Indication

Action

Fan low

Fan runs

continually on low

Fan Medium

Fan runs

continually on

medium

fan high

Fan runs

continually on high

Auto fan

(1)

Fan cycles with

compressor or

electric element

Fan off

No Fan

Note

(1)

: Auto fan changes fan speed with temperature. It also turns off the fan when a cycle is

complete.

7. Home-away-schedule icon. Pressing this button selects between these modes. Home mode is

the normal operating mode using a single setpoint for temperature control. Schedule mode

allows changing set points throughout the day programmatically. Away mode allows setting a

heating and a cooling set point and automatically changing from heating to cooling.

8. The zone selection button will show a zone in green when it is turned on. The zone number will

show in gray if the zone is not available and in red if there is a fault with the zone.

9. Pressing the gear will change the settings screen to allow additional setup functions.

10. Pressing the set point will change the system units from °F to °C and back. The setpoint is also

used as an indicator of system operation. A red set point indicates a heating cycle is in process.

A blue set point indicates a cooling cycle is in process. A white icon indicates no cycle is in

process.

The hourglass symbol indicates that a delay is in process and operation will resume once the

delay is complete. The control board sends this information to the thermostat so it is just an indication

the control board is handling the requested operation.