EasyTouch RV 356 Manual

Initial Setup Instructions

Configure your Available Outputs

EasyTouch RV 356 is meant to replace a few different OEM

thermostats and so must be configured for your system prior to using it.

Tap the Settings button on the main screen, then navigate to the Switches

button and tap it. Tap the heat pump button to enable or disable it based

on what is installed in your system. A red circle with a line through it over

the button indicates disabled. Cool and gas furnace are always enabled.

Auto Gas Changeover Enable/Disable

You can enable or disable auto gas changeover by tapping the

Enable/Disable button under the “Auto Gas Changeover” heading. When

enabled, all of your available heat modes will act in stages based on how

far the inside temperature is from the set-point. See section Auto Gas

Changeover in section Operating the Thermostat for more details.

Auto-Gen Start – Webasto (TrueAir) Systems

Some systems have hardware to allow for a generator to start prior

to a cycle occurring that needs it. The hardware for Auto Gen-Start (AGS)

is not part of the thermostat but it must be configured to know if it is

available.

Tap the AGS Available/Unavailable button under the “Auto Gen-

Start” heading to set it based on what you have. If set as “Available” then

the Generator button will appear and you can turn the functionality on or

off. Setting this to “Unavailable” is the default and should be used for all

non-AGS systems. See section Auto-Generator Start (AGS) in Settings

Screens for more details.

Warning: You MUST configure AGS availability appropriately or your thermostat may not function as

designed. You CANNOT enable this function unless you know you have the appropriate hardware. See

section Webasto (TrueAir) Special Considerations if you are not sure. This can also be found in your

original thermostat’s manual. Micro-Air cannot assist with acquiring AGS hardware.

Connecting Remotely

EasyTouch RV can be operated entirely by the touchscreen, however you

can also communicate, monitor, and modify operation of it wirelessly using the

EasyTouch RV application. Some extra features will require a wireless connection

and is described in their sections. See Appendix A: Working Wirelessly for details.

Settings

Switches

Heat Pump

ENABLED

Auto Gas Changeover

Enable/Disable

AGS Available/Unavailable

AGS Enable/Disable

EasyTouch RV App icon