EasyTouch RV 356 Manual

Figure 4 shows the edit screen when an event

is tapped as shown in (2) Scheduled Events on the main

schedule screen. The event on the main screen and

action time in the edit screen will show disabled until a

time is set. Press “Disabled” (1) at the top of the screen

to show a gray box around the disabled selection. Use

the up and down arrows to make a change. The up and

down arrows change to full color once a selection is

made. Use the back arrow (2) to save any changes and

leave the screen.

Figure 5 shows the schedule edit screen once a valid time

is set for the event.

1. Set the event time by selecting hours, minutes or

AM/PM.

2. Set the desired mode by tapping the mode

button.

3. Tap the hours, minutes, AM/PM or the set point

to select an editable parameter, then use the red

and blue arrow buttons to make a change.

4. Tap the zone number to enable/disable the zone

you want this event to affect. A green box will

draw around zones the event is enabled for. EasyTouch RV models that are not zone controls will

not have this feature and will always be enabled when a valid Action Time (1) is used.

Create and Enable a Schedule

• Tap the edit schedule button as described in the Schedule – Edit, Enable or Disable section in

settings, to enter the main schedule screen, shown by Figure 3.

• Ensure that a valid (3) System Time is shown. Tap the day you want to set up a schedule for, then

the event you want to edit, all shown by Figure 3. Tapping the event will take you to the edit

schedule screen, shown by Figure 5.

• Tap the Action Time, Setpoint and Mode to make edits to what you want your event to do. Tap

the zone you want this event to occur in if shown.

• Tap the back button and repeat for any other events and any other days.

• Tap the back button once again to return to the settings screen and this will save your schedule.

Activate the schedule by pressing the schedule button with the “Enabled/Disabled” subtext as

described in the Schedule – Edit, Enable or Disable section in settings. When enabled, it will be

noted on the Main Screen (3) Status Tray.

Figure 4 - Schedule Edit Screen (Disabled Event)

Figure 5 - Schedule Edit Screen (Enabled Event)