EasyTouch RV 356 Manual

Settings Screens

The settings screens allow for further configuration and control of the

thermostat. It is a paged system that you can navigate through to see all available settings.

Each setting button can be tapped to configure the related settings. Note: Not all settings

may be available depending on your EasyTouch RV model. If you do not see the graphic

then it is not available for your system.

Tap the settings button as shown in section (9) Settings under Main Screen to view them.

Navigation

Use these buttons to flip through all the available settings or return to the main screen.

System Help

This screen displays a QR code that can be scanned to provide information about

thermostat operation and troubleshooting from the Micro-Air website. It also shows the

current thermostat firmware revision and the thermostat serial number.

Day/Night Mode (Screen Saver)

Tap this icon to switch between Day or Night mode. Day mode will dim the display down

to the Sleep Level set in the Display Brightness settings, after 30 seconds of no screen

presses. Night mode will turn the backlight completely off after 30 seconds of no screen

presses. The display will brighten again after a screen press to the Active Level set in the

Display Brightness settings.

Display Brightness

This screen allows you to set the Active and Sleep brightness levels that are used by the

Day/Night Mode (Screen Saver) settings. Tap the associated up and down arrows to

change their level.

Schedule – Edit, Enable or Disable

There are two Schedule buttons with sub-writings “Schedule” or “Enable/Disable”. Tap

the enable/disable button to turn the schedule on or off. Tap the schedule button to

modify the schedule. See section Schedule Screens for more details.

Wi-Fi Information

This screen allows you to monitor the state of your Wi-Fi connection to the thermostat.

SSID and Password fields shows the saved credentials that the thermostat is always

attempting to find and connect to. Tap the password field to reveal the password.

The Router, Strength, and Internet fields show the state of the Wi-Fi connection. The MAC

address of the thermostat is also shown at the bottom. See section Connecting to a New

Wi-Fi Network for more details about using Wi-Fi.

Settings Button

Previous Settings Page

Back to Main

Next Settings Page

Help Button

Day Mode

Night Mode

Brightness Button

Schedule Button

Wi-Fi Button