EasyTouch RV 355 Manual

Gas Heat Override

This feature turns on the gas furnace from an electric heat mode when the set point is five or

mode degrees away from the ambient temperature and heating is required. It is only available on

systems that have both gas and electric heating and is only active in electric heat or cool/electric heat

modes.

If heating set point is 5 degrees or more above the inside temperature in an electric heating

mode, the furnace will come on along with the electric heater. Both will remain on until the set point is

reached. If this action is necessary more than twice in a row, gas heat will be used for the next two

hours without electric heating. This is indicated by a red circle and line through the electric mode

button.

When the furnace is actively overriding the electric heat, a furnace symbol will appear at the top

of the thermostat screen.

Smart device application only features

Reset device

This Bluetooth only feature allows resetting the display just as if you removed and restored

power.

Calibrate Touchscreen

It is normally not necessary to recalibrate the touchscreen. This selection prompts the user to

press the four corners of the display then test the calibration using three diagonal marks. This feature is

only available from Bluetooth.

Check for updates

Check to see if any updates are available for the thermostat. The smart device application must

have internet and the thermostat must be connected to WIFI with a green WIFI symbol. Tap Check for

Updates and follow the prompts.