EasyTouch RV 351 Manual

Gas Heat Override

This function is handled by the control board and not the thermostat. It will activate when the

outside temperature falls below the minimum heat pump operating temperature if available on the

system.

Smart device application only features

Reset device

This Bluetooth only feature allows resetting the display just as if you removed and restored

power.

Calibrate Touchscreen

It is normally not necessary to recalibrate the touchscreen. This selection prompts the user to

press the four corners of the display then test the calibration using three diagonal marks. This feature is

only available from Bluetooth since being at the thermostat is required.

Check for updates

Checks to see if any updates are available for the thermostat. The smart device application must

have internet and the thermostat must be connected to WIFI with a green WIFI symbol. Tap Check for

Updates and follow the prompts.

Notifications

Notifications provide a way for the thermostat to communicate back to a smart device like a

tablet or phone. These notifications are indications of the temperature exceeding a set limit. Limits are

set by connecting to the thermostat in the app, selecting the settings gear, and then selecting

notifications. A minimum and maximum allowed temperature can be set. Table 4 shows an example of

operation with an 80°F maximum temperature set. Notification will be sent for each degree it rises

above the maximum temperature. If temperature drops, no notification will be sent unless the

temperature exceeds the last maximum temperature again (82 in the example). If the temperature

drops two degrees below the set maximum, (78 in the example) it will again alert for each degree above

the set maximum. This behavior helps avoid nuisance notifications to your smart device.

Table 4

Temperature °F

Action

Send first notification

Send another notification

81…79

Temperature drops, no

notification

Max temp resets