Specifications

Installation
MICOM-H Owner’s Guide 58
Microphone Clip
The microphone cable enables placing the microphone clip in any convenient
location up to five feet from the radio. To install the clip, use it as a template to drill
two holes to receive self-threading sheet-metal screws. Mount the clip using the
supplied screws.
Figure 7: Microphone Clip
Final Connections
1.
Connect the power cable to DC connector J4 and connect the antenna RF cable to
antenna connector J2.
If an antenna tuner is used, connect the antenna to the tuner, connect the tuner RF
cable to connector J2, located on the radio rear panel.
2.
If a mounting tray is used, slide the radio with the bracket into the tray and
fasten the bracket to the tray with the supplied screw.
3.
Use the tie straps included with the Cable Kit to tie loose cables out of the way.
4.
Connect a ground lead from the GND screw on the radio rear panel to the chassis
of the vehicle.
!
Warning
Ensure that the radio is off before making these connections.
!
Im
p
ortant
Special attention should be given to locating an appropriate vehicle
ground. Optimum radio performance can only be achieved with a ground
connection having a very low resistance.
The vehicle frame makes the best ground, but body structural
reinforcement members are also suitable for grounding purposes. The
ground lead should be as short as possible.