Specifications

Radio Operation
MICOM-H Owner’s Guide 17
Channel Mode
Options
In Channel mode, you can operate functions and options to eliminate noise and
assist reception and/or transmission. The icon display reflects the options selected.
TXM
(F1) enables you to view and listen to the channel
transmit frequency (visible for duplex and Tx only channels).
BAND
(F2) toggles between upper side band (USB) and
lower side band (LSB).
SQ
(F3) toggles the squelch
(on/off).
DSP
(F4) accesses the Digital Signal Processing menu,
which includes:
•
CLAR
(F1) clarifier
(off/less/more)
* not available for Tx Only channels
•
NF
(F2) notch filter
(off/less/more)
*
not available for CW or Tx Only channels
•
CLIP
(F3) clipper
(on/off)
•
NB
(F4) noise blanker
(on/off)
*
optional, to be purchased separately
•
ATTN
(MORE, F2) attenuator
(on/off).
PWR
(MORE, F1) power level selection
(low, med, high or max).
MODE
(MORE, F2) operation mode selection
(SSB, AME or PLT).
AGC
(MORE, F3) automatic gain control
(fast/slow/off).
BW
(MORE, F4) bandwidth selection
(2.1 K, 2.7 K, 3.0 K, 3.3 K, LSM or CW;
CW includes bandwidths 0.25 K, 0.5 K and 0.8 K,
see “CW Operation” (page 44)).
RCLV
(MORE, MORE, F1) displays the reception level
when F1 is pressed.
*
If the reception is programmed as OFF, this option does
not appear, see “Receive Level” (page 44)
.
Note
The change of channel options is temporary. When you next change the
currently used channel, all current parameters will be lost.
CH 1
BAND LSB
TXM BAND SQ DSP
CH 1
SQUELCH ON
TXM BAND SQ DSP
CH 1
DSP PARAM
CLAR NF CLIP NB
CH 1
CLAR +100
OFF
CH 1
NF –– ––
OFF
CH 1
CLIP
–
OFF
CLAR NF CLIP NB
CH 1
NB
–
ON
CLAR NF CLIP NB
CH 1
ATTEN – OFF
ATTN
CH 1
POWER LOW
LOW MED HIGH MAX
CH 1
MODE SSB
SSB AME PLT
CH 1
AGC FAST
PWR MODE AGC BW
CH 1
BW 3.3
2.1 2.7 3.0 3.3
CH 1
F 10,000.00
RCLV