Specifications

Radio Operation
MICOM-H Owner’s Guide 16
Channel Mode
Channel mode is used to select a channel which is already programmed in the radio,
in order to transmit/receive calls on that channel.
You can also operate a variety of functions and options to facilitate good
transmission and reception.
To choose a channel:
1.
If you are not in Channel mode, press
MENU
to display
the menu screen, and press
CHAN
(F1).
The last active channel number is displayed, blinking.
2.
If you wish to use the displayed channel, press
ENTER
.
OR
Select a channel by pressing the
UP
/
DOWN
keys until you
reach the required channel, or use the keypad to enter the
channel number.
The channel number blinks, indicating that the selection has not yet been
confirmed.
3.
When the desired channel is displayed, press
ENTER
to confirm your choice.
To transmit in Channel mode:
1.
If you are not in Channel mode, press
MENU
to display
the menu screen, and press
CHAN
(F1).
2.
Choose a channel (see above).
3.
To initiate transmission, press the PTT button.
Note
In order to choose the priority channel, you must be in Channel mode. To enter
channel mode, press
MENU
>
CHAN
(F1) and confirm by pressing
ENTER
.
To access the priority channel preprogrammed by the RSS, press
ESC
momentarily.
Note
If you enter a channel that is not programmed, a “NOT PROG”
message appears. To program a new channel, see
“Programming Channels” (page 32), or use the RSS software.
MENU
CHAN FREQ SCAN BIT
CH 1
CH 2
BACK CLR
MENU
CHAN FREQ SCAN BIT