Specifications

MICOM-3TS-RDP Owner’s Guide
12
MICOM-3TS-RDP Connections
Most connections are made to the connectors in the connector panel of the MICOM-3TS-RDP (with
the exception of the microphone, which is connected directly to the front panel of the MICOM-3
radio control head).
GND
ANTENNA
BAT. 12V
FUSE 6.3A S.B
SYSTEM
AC POWER
85-267 VAC
AUTO
Figure 8. MICOM-3TS-RDP Connector Panel
Connecting the MICOM-3TS-RDP to Grounding
It is highly recommended to connect the MICOM-3TS-RDP suitcase to the ground. Optimal
performance is achieved with ground connection of a very low resistance.
The GND terminal in the connector panel of the MICOM-3TS-RDP should be connected to
grounding such as water piping in a building, a grounding rod or a vehicle chassis.
1/4” Lockwasher
Thoroughly
Clean this Area
Chassis Cable
and Lug
Floor Surface
14x3/4"
Self-Tapping
Screw
3/16' (187")
Diameter Hole
Figure 9. Ground Connection to Vehicle Chassis
Connecting a Microphone
Connect the microphone to the MIC connector on the front panel of the MICOM-3 radio control
head.
Connecting the MICOM-3TS-RDP to the Power Source
The MICOM-3TS-RDP can be connected to the following power sources:
•
12V negative ground vehicular battery
•
110V/220V AC, 47 to 65 Hz power source.
Note
Always connect the power supply cable to the MICOM-3TS-RDP before
connecting the other end of the cable to the power source.