Product Info

fitment of the wired receiver
Please connect the RED Wire directly to a vehicle 12V/24VIgnition fed power supply (Positive).
The Black Wire is connected to a Ground wire (Negative).
Consult manufacturers wiring guidelines where applicable to avoid any warranty issues.
Remove the backing from the adhesive pad at the rear of the receiver taking care not to touch the adhesive
surface.
Normal Operation Mode
The “Michelin” Logo will be permanently lit WHITE.
Stationary Sleep Mode
When the vehicle is stationary for more than 15 minutes and with the ignition on the receiver will go into
Stationary Sleep Mode. No Lights will be on at all in this mode.
No Power
If the receiver has no power during a journey then the “Michelin” Logo will not be lit. This situation must
be remedied by reconnecting to the power source.
4
The receiver should be mounted on a clean even flat surface so that it does not obscure the view of the
road or any instrumentation but is clearly visible to the driver from a normal driving position.
ENSURE THAT THERE ARE NO TRAILING WIRES AFTER INSTALLATION.