Instruction manual

2. REPLACEMENT OF THE FRONT SQUEEGEE BLADE
If the front squeegee blade is worn, good vacuum is not achieved and the machine will
not dry the floor well. Replace as follows:
1. Detach the squeegee from the machine (2).
2. Loosen the screws that attach the front blade.
3. Slip off the squeegee blade and replace it.
4. Reassemble.
19
WEEKLY MAINTENANCE
1. REPLACEMENT OF THE REAR SQUEEGEE BLADE
If the rear squeegee blade is worn and does not dry the floor well, reverse the cleaning
edge or replace it as follows:
1. Push the fixing plates (1) by tapping with a hammer, then rotate them.
2. Slip off the retainer and the squeegee blade.
3. Turn the squeegee blade upside-down or if necessary, replace it.
4. Reassemble everything repeating the above operations in reverse.
5. Adjust the squeegee height depending on the squeegee blades wear (see under
“SQUEEGEE ADJUSTMENT”).
3. CLEANING THE SQUEEGEE HOSE
Weekly or whenever the suction is insufficient, make sure the squeegee hose is not
obstructed. Also, clean it with water introduced from the side where it is connected to
the tank. Proceed as follows:
1. Lift the solution tank
2. Take off the vacuum hose from the recovery tank.
3. Wash the inner part of the hose with a water jet from the tank side.
4. Reassemble.